110mm Continuous Rim Diamond Blade for Wet and Dry Cutting

Updated: 2026-10-08

The 110mm Continuous Rim Diamond Blade for Wet and Dry Cutting is an OEM-ready blade reference for stone cutting. Before quotation, the buyer and manufacturer should agree on stone abrasiveness, slab thickness and required edge quality, the machine interface and the test method.

Product reference: Catalogue #2645 identifies this configuration during sampling and quotation.

Dimensions and listed application

• Diameter: 110mm
• Bore: 20mm
• Segment height: 10mm
• Thickness: 1.8mm
• Applications: granite, sandstone, rock slabs, marble cutting.

The stated diameter is 110mm, with bore information shown as 20mm. Measure the spindle and check the guard capacity before choosing a reduction ring or flange arrangement.

What this design should be checked against

Listed use: granite, sandstone, rock slabs, marble cutting.. The continuous rim is intended for buyers who place edge control ahead of aggressive chip clearance. For approved dry cutting, use controlled passes and cooling intervals instead of forcing the blade through the workpiece. For wet cutting, confirm that the machine can deliver clean water to both sides of the rim.

The stone cutting category contains other dimensions for comparison.

Preparing an OEM enquiry

To compare quotations fairly, send every supplier the same material, machine and output requirements. Shandong Huada Jinke New Materials Co., Ltd. can then confirm the drawing, sample quantity and schedule.

Before a volume order

A controlled sample test is more useful than a general claim. Keep material, operator, cooling and feed conditions consistent, and photograph the edge and wear pattern after the test.

Send a product enquiry and include reference #2645 with the machine and material details.